Setting up a Brick Paver Walkway or Refractory Fire Brick

The use of Bricks or Pavers to produce a walkway or patio complements a house in a method that is unequaled. In addition, installing a Brick or Paver walkway does not necessarily need a pro.

The secret to setting up a Brick or Paver Walkway is to first appropriately prepare the area where the bricks/pavers are to be installed. In addition, string lines must be strung on each side of the pathway.
When the area has actually been dug, 3/4" gravel stone ought to be laid in and tamped down firmly. Then 2" of sand, or stone dust ought to be topped the gravel. Again the sand/stone dust need to be tamped down. Stone dust is chosen. The height between the tamped down sand and the stringline must equate to the thickness of the brick or paver.

Now that you have a steady base, position a 1" pipeline or journal board the length of the pathway on either side of the pathway. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will create a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Set up a run on both sides of the prepared area. These strips will act as your sidewalk border and aid here to maintain the stability and shape of the sidewalk.

The key to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will again assist keep the integrity of the pathway.

Inevitably bricks/pavers will require to be cut or divided when developing the walkway. To actually cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the spot where you want to break the brick. If your walkway here has curves you will require to buy/rent a wetsaw.

After setting up the bricks, develop the outside edges with additional sand, and after that shovel in the topsoil and pack down firmly.
Spread stone dust over the new pathway and sweep into the fractures. This will finish the interlocking of the bricks and help to remove any here weed growth.


In addition, setting up a Brick or Paver pathway does not necessarily need a pro. The key to installing a Brick or Paver Walkway is to first appropriately prepare the location where the bricks/pavers are to be set up. Now that you have a steady base, place a 1" pipeline or journal board the length of the pathway on either side of the walkway. These strips will act as your sidewalk border and assistance to maintain the integrity and shape of the sidewalk. Inevitably bricks/pavers will require to be cut or split when building the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *